Publish Time: 2021-05-20 Origin: Site
In our daily life, we have used rast connectors very much. To some extent, we cannot live so conveniently without rast connectors. They have been applied to almost every aspect of our life. It is very simple but important. As a bridge to build communication between blocked or isolated circuits in the circuit so that the current can flow and the circuit can realize the predetermined function.
Following are some key points about rast connectors:
How to remove rast connectors?
How do you store your unused rast connectors?
When disconnecting rast connectors, hold them. For connectors that are fixed with screws, loosen the screws completely, and then use two hands to hold the male and female connectors and pull them out. For connectors with locking reeds, press down on the reeds with your thumb and pull the connector out. Never pull with one hand.
When removed from the clamp both the rast connectors and the clamp have stop blocks, and when rast connector is installed, they engage with each other. When removing the connector from a clip, pull out the connector in a direction parallel to the clip to disassemble the stopper. If the rast connector is twisted up and down or left and right, the shell may be damaged.
Measures must be taken after removing the rast connector. After removing any connector, cover a polyethylene bag to prevent dust, sludge, oil, or water from entering the connector part. If the machine is in a disassembled state for a long time, it is particularly prone to poor contact, so the rast connector must be wrapped.
When using the connector, it must be used and stored correctly to avoid unnecessary trouble. When you do not use rast connector, for the time being, do not place the connector arbitrarily, especially in a place with sunlight. If you forget to place it due to negligence, the connector will be damaged due to long-term sunlight exposure, which will affect the quality of rast connector. Its use may even cause safety accidents, so we must carefully remember where the connector can be stored, and must not cause safety accidents due to negligence.
Rast connectors are not allowed to be placed in high temperature places. Continuous high temperature or high humidity will damage the rast connectors, especially in the environment with chemicals, the connectors will be corroded, and the metal protective layer on the outside will lose its protection. The effect of this causes the destruction of the current lines inside. Without the normal conductive function, it becomes a waste.
When you need to move the connector, don't panic. Be careful to avoid the rast connector from touching hard objects and causing damage to the connector. Don't put it under heavy objects to avoid crushing the connector.
There is another enemy to rast connector, that is, grease-like objects. During storage or use, if the grease-like objects are touched, rast connector will lose its original function and become an obstacle that affects our work.
We have been manufacturing connectors for16 years with rich experience in designing different kinds of connectors that you need. We provide connectors like rast 2.5 connectors, rast 2.5 power connectors, rast 5.0 connectors, RF connector, circular connector, wire to wire connector wire to board connector, LED lighting connector and automobile connector. If you need any rast connectors, please contact us.